ISUTAMI BEARINGS
en
2 Bolt Flange Mounted Unit Pressed Steel
E-catalog
ISUTAMI BEARINGS

2 Bolt Flange Mounted Unit Pressed Steel

2 Bolt Flange Mounted Unit Pressed Steel
ISUTAMI 2-bolt pressed steel flange mounted unit, also known as ISUTAMI 2-bolt diamond pressed steel flange mounted unit, is a combination of a pressed steel housing and a spherical bearing. It is an important device in transmission mechanical system. The mounted bearing is in a diamond-shaped flange housing, which is made of low-carbon steel strip with the zinc-plated surface for corrosion protection. Each side of the flange has a square bolt hole for fixing and mounting the bearing unit. The spherical bearing installed in the bearing housing is a rolling ball one, which mainly serves to reduce the friction of the equipment during working. There is a dust-proof rubber race on each side of the bearing. Moreover, the inner ring of the bearing is generally divided into two types: a set screw locking type and an eccentric collar locking type, and the round shaft can be fit for the specific inner ring size.
2 Bolt Flange Mounted Unit Pressed Steel
ISUTAMI 2-bolt pressed steel flange mounted unit, also known as ISUTAMI 2-bolt diamond pressed steel flange mounted unit, is a combination of a pressed steel housing and a spherical bearing. It is an important device in transmission mechanical system. The mounted bearing is in a diamond-shaped flange housing, which is made of low-carbon steel strip with the zinc-plated surface for corrosion protection. Each side of the flange has a square bolt hole for fixing and mounting the bearing unit. The spherical bearing installed in the bearing housing is a rolling ball one, which mainly serves to reduce the friction of the equipment during working. There is a dust-proof rubber race on each side of the bearing. Moreover, the inner ring of the bearing is generally divided into two types: a set screw locking type and an eccentric collar locking type, and the round shaft can be fit for the specific inner ring size.

2 Bolt Flange Mounted Unit Pressed Steel Products


2 Bolt Flange Mounted Unit Pressed Steel Features

ISUTAMI stamped steel housings are lighter than the cast iron housings. The maximum size of 2-bolt pressed steel flanged housing unit does not exceed 1 kg; the volume is smaller, but this type of housing unit can only be used for where the load is small. At present, ISUTAMI can provide three different types of products: UCPFL series pressed steel mounted unit, SBPFL series pressed steel mounted unit and SAPFL series pressed steel mounted unit. Among the three products, UC200 series ball bearings, SB200 series ball bearings and SA200 series ball bearings are matched with PFL series bearing casing to form corresponding bearing units. ISUTAMI 2-bolt pressed steel diamond-type flange mounted bearing unit is widely used in the transmission system, because the product is easy to disassemble and install, and has a long service life under harsh conditions, which has attracted more and more customers' attention.

In addition, ISUTAMI can design and produce more 2-bolt diamond pressed steel flange mounted units for the required sizes to meet the specific needs of customers.
  • TEL:+86-574-6399-8066
  • FAX:+86-574-6399 8025
  • EMAIL: sales@isutami.com
  • ADDRESS:No.500, North 3rd Ring Road West, Cixi, Ningbo, 315300, China