ISUTAMI BEARINGS
en
Stainless Steel Insert Bearing
E-catalog
ISUTAMI BEARINGS

Stainless Steel Insert Bearing

Stainless Steel Insert Bearing
ISUTAMI Stainless Steel Insert Bearing a variant is actually the deep groove ball bearings, Stainless Steel material, characteristic is its outer diameter for spherical surface, can match into the corresponding concave spherical bearing self-aligning effect. Stainless steel is suitable for the requirements of a special environment, and its combination with ISUTAMI stainless steel Pillow Blocks will prolong its service life.

ISUTAMI Stainless Steel Insert Bearing is suitable for the required equipment and parts matching, such as used for agricultural machinery, transportation systems or on construction machinery.
Stainless Steel Insert Bearing
ISUTAMI Stainless Steel Insert Bearing a variant is actually the deep groove ball bearings, Stainless Steel material, characteristic is its outer diameter for spherical surface, can match into the corresponding concave spherical bearing self-aligning effect. Stainless steel is suitable for the requirements of a special environment, and its combination with ISUTAMI stainless steel Pillow Blocks will prolong its service life.

ISUTAMI Stainless Steel Insert Bearing is suitable for the required equipment and parts matching, such as used for agricultural machinery, transportation systems or on construction machinery.

Stainless Steel Insert Bearing Products


Stainless Steel Insert Bearing Features

It is mainly used to bear the combined radial and axial load which is mainly radial load. Generally, it is not suitable to bear the axial load alone. This kind of bearing can be installed with inner ring and outer ring respectively. The bearing is not allowed to tilt the shaft relative to the housing, and additional axial force will be generated under the radial load. The size of the axial clearance of this kind of bearing has a great influence on whether the bearing can work normally. When the axial clearance is too small, the temperature rise is relatively high. When the axial clearance is large, the bearing is easy to be damaged. Therefore, special attention should be paid to adjusting the axial clearance of the bearing during installation and operation. If necessary, pre-interference installation can be carried out to increase the rigidity of the bearing.

ISUTAMI Stainless Steel Insert Bearing belongs to the low vibration bearings, Bearing noise control by controlling Bearing vibration, direct captures the source and the cause of the noise, such as measuring vibration less affected by environmental conditions, basic easily separation and easily applied in the actual production.

ISUTAMI Stainless Steel Insert Bearing production process from the peel, indentation, rust, crack and wear will be reflected in the outer spherical Bearing vibration measurement, the Bearing vibration on Bearing damage is very sensitive, so the Bearing through the use of special Bearing vibration measurement can measure the size of the vibration, through frequency points cannot deduce the abnormal situation. Since the measured value varies with the use condition of the bearing or the installation position of the sensor, it is necessary to analyze and compare the measured value of each machine before determining the judgment standard.
  • TEL:+86-574-6399-8066
  • FAX:+86-574-6399 8025
  • EMAIL: sales@isutami.com
  • ADDRESS:No.500, North 3rd Ring Road West, Cixi, Ningbo, 315300,China