SUCTB200 Stainless Steel Mounted Bearings

ISUTAMI stainless steel mounted bearings in the use of axial bear strong impact, will produce scar and creasing, become the cause of the accident.In severe cases, cracks and fractures can occur, so prevention must be made as soon as possible.In the shaft and bearing seat, the bearing is required to fix its position in the radial, axial and tangential directions.Radial and tangential positioning is realized through the tight fit of the bearing ring. Axial positioning only USES tight fit in a few cases.In general, axial limiting parts, such as end caps and baffles, are used to limit the axial position within the clearance range.The circumferential surface of the bearing ring should be well supported and stressed evenly to reduce deformation and give full play to the bearing capacity of the bearing.The ring cannot slide along the tangent direction in the mating surface, otherwise it will damage the mating surface.The free-end bearing must be able to adapt to the length change of the shaft and the bearing seat hole, that is, it must have the ability to swim within a certain range to adapt to the axial position.Must pay attention to make the bearing installation and disassembly simple, save time and money.When operating bearings, the sweat on the hands can be the cause of rust.Be careful to use clean hands, preferably with gloves.