ISUTAMI BEARINGS
en
Installation Considerations
ISUTAMI BEARINGS

Installation Considerations

  • have clearance fit, the bearing ring Suggestions on the fitting surface coated with a thin layer of preservatives, prevent the friction between mating surface corrosion.
  • when installation on bearing force, not by pass from a roller bearing ring to a bearing ring, otherwise it may cause damage to the race.Do not directly hit the bearing ring, retainer, roll or seal.
  • eccentric sleeve.The eccentric sleeve is first set on the eccentric step of the bearing sleeve, and is first tightened by hand; then the small iron bar is inserted into the sunken hole of the eccentric sleeve, and the small iron bar is struck with the hand hammer in the direction of rotation, so that the eccentric sleeve is installed firmly, and finally the screw on the eccentric sleeve is locked.
  • fixed bearing bolts do not tighten, then good bearing bolts.The bearing and seat on the other end of the same shaft shall be installed, and the bearing shall be adjusted to the correct position automatically before finally tightening.
  • coating on surface of the bearing and the bearing lubricating oil, put the bearing into the bearing seat.The assembled bearing is then sleeved on the shaft together with the bearing seat and pushed to the required position for mounting.
Correct installation of bearing can not only increase the service life of bearing, but also greatly improve production efficiency.
  • TEL:+86-574-6399-8066
  • FAX:+86-574-6399 8025
  • EMAIL: sales@isutami.com
  • ADDRESS:No.500, North 3rd Ring Road West, Cixi, Ningbo, 315300, China