ISUTAMI BEARINGS
en
Installation and Disassembly of Rod End Joint Bearing
ISUTAMI BEARINGS

Installation and Disassembly of Rod End Joint Bearing

1. Where press is not available or not available, bearing can be installed with assembly sleeve and hammer. The hammering force should be transmitted evenly to the whole circumference of the end face of the cheap rod end joint bearing ring, so the end face of the assembly casing hammered should be spherical.

2. The force required to install cheap rod end joint bearings is related to the size of the joint bearings and the size of the fit interference. For medium-sized or large-sized joint bearings with larger interference, the hot-fitting method is commonly used. Before hot charging, put the bearing or separated joint bearing ring into the oil tank or special heater and heat it evenly to 80-100 C, not more than 100 C.

3. Hot-loaded and cheap rod end joint bearings require skilled operation skills. When the joint bearing is removed from the heating tank or heater, the oil marks and attachments on the surface of the joint bearing should be wiped off immediately with a clean cloth, then placed in front of the matching surface, and the joint bearing should be pushed to the place where it is held against the shoulder in one operation. During the cooling process, it should always be pushed tightly, or the joint bearing should be tightened by tapping the assembly sleeve with a hammer. When installing the end, the joint bearing should be slightly rotated to avoid dumping or jamming.

4. When the outer ring and shell hole of the cheap rod end joint bearing are tightly matched, the shell can also be heated and loaded into the joint bearing. In particular, light metal joint bearings, in the process of tight fitting, may cause damage to the mating surface due to its outer ring pressing. In this case, the bearing should be heated first.
Related News
  • Bicycle Headset Bearings

    Bicycle Headset Bearings

    February 26, 2019The headset is the set of components on a bicycle that provides a rotatable interface between the bicycle fork and the head tube of the bicycle frame itself. The short tube through which the steerer o...view
  • Basic Knowledge of POM, PP, PE and Other Plastic Mounted Bearings

    Basic Knowledge of POM, PP, PE and Other Plastic Mounted Bearings

    May 28, 2019Speaking of plastic mounted bearings we all know that the current use of plastic mounted bearings can generally be divided into plastic rolling bearings and plastic sliding bearings.In recent years, e...view
  • The Construction Of Spherical Plain Bearings

    The Construction Of Spherical Plain Bearings

    August 30, 2018Spherical plain bearings are a bearings that permit angular rotation on a central point in two orthogonal directions. Typically these bearings support a rotating shaft in the bore of the inner ring th...view
  • Small Bearings Occupy Large Market

    Small Bearings Occupy Large Market

    August 30, 2018It is well-known that the auto bearings are the core parts of the automobile. They are closely related to the reliability, safety and comfort of the automobile, though they small parts. As the experts...view
  • ​ ​What Is Preload of Linear Bearings?

    ​ ​What Is Preload of Linear Bearings?

    December 22, 2019A linear bearing that has been preloaded is like shoes that have been broken in. Those shoes will be much more comfortable and you’ll get much more enjoyment out of them. On the other hand, if you de...view
  • What is a pillow block bearing?

    What is a pillow block bearing?

    May 9, 2019A pillow block bearing consists of a mounting bracket (pillow block) that houses a bearing and is used in low-torque, light load applications.With this configuration, the pillow block is bolted to a f...view
  • TEL:+86-574-6399-8066
  • FAX:+86-574-6399 8025
  • EMAIL: sales@isutami.com
  • ADDRESS:No.500, North 3rd Ring Road West, Cixi, Ningbo, 315300, China